A few weeks ago, I altered the rear cleat position for the mizzen sheet. I cut a mahogany block from some old scrap timber I had lying around and angled it slightly along one face so that when offered up to the back coaming it lay slightly angled downwards. Screwed into the coaming, the cleat was added.
I have to say it works; and works well indeed. Not pretty but definitely functional. No more scrabbling around to secure the mizzen sheet; just one sharp tug downwards does the job. Wonderful.
So now I have to do the same with the jib side cleats. Now when solo sailing, I just let the jib sheets pass through the coaming hole and down to the rear of the centre case top. Here one of them passes through a huge deck loop before being tied to the other jib sheet. In this way, I never lose a jib sheet and they are easily jammed into the cleat on the aft end of the centreboard case cover.
However with crew in the boat, it has been necessary to part the sheets and the crew fumbles to try and secure it low down to their side. These new blocks should stop that from happening. However, I need to make them low profile one so that they don't dig into the crew's ribs or get accidentally knocked off the coaming by an over vigorous crew member.
I'll let you know how they turn out
Steve
I have to say it works; and works well indeed. Not pretty but definitely functional. No more scrabbling around to secure the mizzen sheet; just one sharp tug downwards does the job. Wonderful.
So now I have to do the same with the jib side cleats. Now when solo sailing, I just let the jib sheets pass through the coaming hole and down to the rear of the centre case top. Here one of them passes through a huge deck loop before being tied to the other jib sheet. In this way, I never lose a jib sheet and they are easily jammed into the cleat on the aft end of the centreboard case cover.
However with crew in the boat, it has been necessary to part the sheets and the crew fumbles to try and secure it low down to their side. These new blocks should stop that from happening. However, I need to make them low profile one so that they don't dig into the crew's ribs or get accidentally knocked off the coaming by an over vigorous crew member.
I'll let you know how they turn out
Steve
No comments:
Post a Comment