It is always difficult selling something that is much loved. But we have finally bitten the bullet and posted the following sales notice for our beloved motovespa 'Stacey'. Hopefully we will get her to a new home where she will be just as appreciated and so some of the following details appeared on FaceBook, Gumtree and Ebay selling pages. I felt the same way about each car we have traded in. It never gets any easier. Lord knows how I will be if I ever sell Arwen............................
For sale much loved Douglas Vespa small
frame Motovespa 125cc super model year 1971 and first registered July 1972 registration ******K.
762M***** on engine Vin frame prefix number 762C***** on frame.
Research on various websites shows it to be a Motovespa 125 super 1965 although
I cannot guarantee that this is 100% accurate.
Kick start, two stroke, pre-mix, petrol
and 4 speed manual gear. Tax exempt (Historic vehicle) and MOT’D until February 2018. Ready to
ride with 11,280 on clock; speedo is in mph. Original mileage when bought was 10,200.
V5 and original registration document
from 1971 present (matching chassis and engine numbers); previous MOT’s and
service history present whilst in our ownership. Has been stored in garage
since we have owned it and ridden once per month on average until Feb 2017 when
then SORN’d and stored under cover in garage (son was away for year). Has been
started every month since with no problems and recently passed MOT with no
advisories.
Restored from old barn find as
father/teenage son project over two years. Son is now away from home and saving
for car and so this is a ‘reluctant’ sale.
Have receipts for most items – all from SIP, AJ Sutton, Allstyles or
Beedspeed. Many original features remain.
Restoration
work included:
·
Strip down to bare metal and rust removal; Professionally done primer and new paint
job – metallic burgundy red
·
New 10 inch white wall tyres and inner tubes – original rims
·
New floor panel and floor runner kit
·
Engine strip down and replaced all bearings, seals, gaskets, new
piston. Had previous Malossi cylinder headset conversion at some stage and also
a CDI conversion by previous owner.
·
New shock absorbers front and rear
·
new speedo cables and gearing (installed by local scooter
expert)
·
New fuel tap; petrol tank cleaned out
·
New FACO ET3 banana exhaust and air filter
·
New carb dell'orto SHBC 19/19 and intake manifold
·
New handlebar clutch and brake levers
·
New wiring loom inserted by local scooter expert along with new
headlight glass; new rear brake light holder and gasket
·
New brake shoes front and rear
Original features, as far as we know -
speedo, rims and hubs, spare wheel holder, most of engine. Please note: we were new to vespa scooters and so kept as much of the
original features of scooter that we bought. We cannot vouch that what we
bought was all original – please see note below about toolbox for example.
People should remember engine
may need little more running in still.
Runs perfectly – starts on third kick normally. Engine and carb needs slight tuning – Can see videos on YouTube....search Motovespa 125 super or plymouthwelshguy and look for playlist.
Runs perfectly – starts on third kick normally. Engine and carb needs slight tuning – Can see videos on YouTube....search Motovespa 125 super or plymouthwelshguy and look for playlist.
Other videos can be found in my playlist on my youtube channel at
Notes:
We have tried to describe ‘Stacey’
in as much detail as possible. In good faith please note the following:
1. Minor cosmetic scratches on engine panel.....it fell off once! See photos/video
1. Minor cosmetic scratches on engine panel.....it fell off once! See photos/video
2. Being naïve, we had the
parts and frame sandblasted and then powder coated…that was before we realised
or managed to get plugged in to the local scooter scene and small frames Vespa
forum
3. Deep scratch on bottom of rear front mudguard where bolt on front leg shield once caught it
3. Deep scratch on bottom of rear front mudguard where bolt on front leg shield once caught it
4. Big note.....when we restored it we didn't know anything about scooters and so didn't realise that bottom of leg shield had small part cut out by previous owner....see one of the photos. May need piece welded back in. We have gone on journeys of 150 miles in a day. It has never been a problem. The ‘hole’ is currently covered with black duct tape which has held for four years! The back of the hole does have cross piece in it which maintains structural integrity – see photo
5. The right hand throttle mount on headset broke when an over eager observer
leaned against scooter heavily and knocked it over. We had local engineering
company cut and bolt in new aluminium plate. Never been a problem, headset fine
and throttle and brake works perfectly. However some paint and powder
coating lost on edge – see photo
7. The toolbox was fitted at later stage by previous owner and isn't actually the correct motovespa toolbox.....again, we didn't know until much later after the restoration was complete.
8. Light switch box keeps
coming loose and is held on with tape – see photo
9. Crack in paintwork on one
part of floor panel - see photo
We
have tried to be completely honest via description, photographs and video
clips. But if we can help in any other way, please ask.
Thank you for your time and interest. ‘Stacey’ provides a great ride, is much
loved and we part with her reluctantly. Looking for an owner who can tune her,
restore her further and treasure her as much as we have. UK buyers only and buyer must arrange own collection please. Seller
doesn’t accept any returns. Thank you for your interest. Have a good week. PLEASE SEE BELOW PHOTOGRAPHS FOR PRICE AND PAYMENT DETAILS
Payment
details:
Price
is £2,700 : no other offers please.
Payment
can be any of the following ways but please note conditions attached.
1.
by PayPal into my PayPal account and monies must clear to my account
BEFORE scooter is collected.
2.
By cheque to my bank account – again cheque must clear and monies
enter the account BEFORE scooter is collected (minimum seven working days and
confirmation from my bank on receipt of money)
3.
Online bank transfer but subject to me being able to confirm
that my branch has received monies in to my account
4.
By bankers draft but
again cheque must clear (minimum seven days) before you can collect scooter
If you would like to view - contact me via FaceBook or on this blog comment box below. No tyre kickers or time wasters please. You can see it start up but no asking for rides please as I don't know your insurance details; and my insurance covers it only as SORN'd. Thanks for understanding - there is plenty of video evidence to show it runs fine and it has just passed its MOT.
No comments:
Post a Comment
Thanks for taking a look at my blog. All comments and advice are welcome - drop me a few lines. You can always find videos about Arwen at www.youtube.com/c/plymouthwelshboy. Look forward to hearing from you.
Steve